Deploying Simulink code to hardware using Matlab's command line

Hello, is it possible to deploy some .slx code to hardware using some opportune Matlab command? I have been succesfully launching an external-mode simulation using "open_system('my.slx')" and "set_param('my.slx', 'SimulationCommand', 'start')", but I did not find a command that deploys the .slx to hardware.

Any hints? Thanks in advance!

Answer 1

[Vaibhav Awale]

Hi,

You can refer to following documentation links for command line functions to deploy simulink models:

Configuring Model from Command Line

Build, Load and Run

Hope this helps.

Regards,

Vaibhav

[Victor Bayer]

the build Load Run link seems to be out of date. Could you please provide a new one? I am trying to deploy a Simulink model from the command line on a raspberry pi and do not know how.