Set configuration parameter in Simulink

Hi,

I have to run a simulink model from a script in Matlab. I'm using the sim command to run the model but I not find the right command to set the initial state. I am able to do it from the model (Simulation --> configuration parameters --> initial state) but I have some problem to do it from a script. Could anyone suggest me a solution?

Thanks

Answer 1

[Sebastian Castro]

For all configuration parameters in a model, you can right-click them and select "What's This?" This will bring up a small window which contains a table showing you the command-line way to use that particular parameter.

Following the above workflow, the parameters you care about are LoadInitialState and InitialState

You can do this either by using set_param before running the model or in the sim command itself.

>> set_param(bdroot,'LoadInitialState','on','InitialState','variableName');
>> simout = sim(bdroot,'StopTime','10');

>> simout = sim(bdroot,'StopTime','10','LoadInitialState','on','InitialState','variableName');

- Sebastian

[Alessandra Cuneo]

Thank you so much...I implemented in the code and it works!