Response optimization: Unable to get the optimization due to check custom bound error
1 回表示 (過去 30 日間)
古いコメントを表示
I created a simscape block for injector. I am interested to tune the parameter values of some input blocks values within the range known. I saved the parameters in 1 set as 'Design variable in optimisation windows session'. I created a check custom bound block in file - with the upper and lower bounds values: the upper is a profile(>0) and the lower bound as the 0 for upto 0.006s time. But when i try to run for optimization : I get the following error: Design Optimization 1 9:34:57 PM Aug 29, 2015 Elapsed: 0.342 sec
The requirements applied to 'Injector_optimiser/Check Custom Bounds' do not admit a feasible solution. The requirements 'Upper signal bound from '0.0000' to '0.0060' seconds.' and 'Lower signal bound from '0.0000' to '0.0060' seconds.' must not overlap.
Component: Design Optimization | Category: Optimize error
I am not well versed in optimization sequence or tools, I was following the tutorials in matlab sites - seeing suspension examples. I can share my file if needed, waiting for some advice to solve this issue.
regards,
sanjeet
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/148564/image.png)
Upper /lower bound
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/148565/image.png)
0 件のコメント
回答 (0 件)
参考
カテゴリ
Help Center および File Exchange で Simulink Design Optimization についてさらに検索
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!