problem with transmission block simscape
1 回表示 (過去 30 日間)
古いコメントを表示
Hello, I'm modelling a vehicle transmission with the block "transmission" that you can find in simscape. It's an 8 speed transmission, I set the logic to change gear, but the vehicle stops at 2 km/h. If I use a simple gear with a certain gear ratio it works. If i keep the transmission connected and i increase by 100 times the inertia of the engine it slowly accelerate. what I should check, is there a recent example where the transmission block is used? thank you
0 件のコメント
回答 (1 件)
Akshat
2023 年 10 月 2 日
編集済み: Akshat
2023 年 10 月 3 日
I understand that you are facing issues while leveraging the 'transmission' block in Simscape. Since your focus is on 8-speed transmission, the following references could provide valuable insights and assist you in resolving the issue.
I hope this helps.
0 件のコメント
参考
カテゴリ
Help Center および File Exchange で Automotive Applications についてさらに検索
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!