How to connect Raspberry Pi to DAC MCP 4921 using SPI Simulink blocks?
4 ビュー (過去 30 日間)
古いコメントを表示
I want to set an output voltage with a RaspberryPi with an DAC MCP4921 using Simulink, in particular using the new block "SPI Register Write" available in the latest Simulink version (without writing C code or Matlab code). In this block is required a Register Address where SPI has to write the value from the slave. Can anyone help me?
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/1278940/image.png)
1 件のコメント
Sylvain
2023 年 2 月 16 日
Looking at the datasheet, the write command register is not defined.
Can you try the "SPI Master Transfer" block with a terminator for the output?
You should send the a vector of [2x1] uint8 for the upper half and the lower half.
回答 (1 件)
Mark McBroom
2023 年 2 月 5 日
Would you want to use the SPI Read/Write/Master blocks to communicate with this external device, similar to this example that uses SPI to communicate with an external EEPROM device?
https://www.mathworks.com/help/supportpkg/raspberrypi/ref/communicating-with-an-eeprom.html
0 件のコメント
参考
カテゴリ
Help Center および File Exchange で Modeling についてさらに検索
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!