フィルターのクリア

Finding the frequency response of data collected from a DAQ

1 回表示 (過去 30 日間)
Jason Fender
Jason Fender 2011 年 2 月 22 日
I have a cantilever beam with motor attached to the end of the beam. The motor works a rotating mass. The speed of the motor was adjusted until the natural frequency of the beam was found. At that point, data was taken with a DAQ so I have data with corresponding times. My end goal with the data is to make a frequency response but I have no idea where to begin. I've been messing around with the freqs command in Matlab, but I haven't had any luck. Any help would be greatly appreciated.
If there is a way to upload my .txt file of data and if it were helpful to anyone, I'd be happy to.

回答 (1 件)

Rob Purser
Rob Purser 2011 年 2 月 22 日
Check out this in the file exchange. It might help to get you started.
All the best,
-Rob

カテゴリ

Help Center および File ExchangeMATLAB についてさらに検索

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by