Simscape thermal model for wire embedded in polymer
6 ビュー (過去 30 日間)
古いコメントを表示
Hi everyone,
I am trying to model the temperature change of a wire embedded in a polymer material (see figure below). On the other hand, I would like to monitor the temperature change at the upper surface. My question is if it is possible to use the "Temperature Sensor" block to measure a specific point (e.g. the midpoint) of the temperature on the top side?
Thanks in advance
Ozan
0 件のコメント
回答 (1 件)
Nirupama
2024 年 1 月 22 日
As far as I know, you cannot read the tempertaure at a specified location in a body using "Temperature Sensor" block. Simscape models are lumped parameter models, meaning that each block represents a "lumped" average state of a component. For example, volume of the tank block has an average temperature, rather than a distribution of temperatures. In some cases, like the pipe, a temperature distribution is assumed to calculate heat transfer accurately, but the state of the block is still just a lumped temperature value.
Regards,
Nirupama
0 件のコメント
参考
カテゴリ
Help Center および File Exchange で Elements についてさらに検索
製品
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!