ROS Simulink algebraic loop

6 ビュー (過去 30 日間)
Tristan Sinnecker
Tristan Sinnecker 2022 年 3 月 4 日
回答済み: stozaki 2022 年 3 月 4 日
Dear all,
I am tryining to build up a HIL environment by using ROS in Simulink. If I try to run a simulation, I get the following error:
"Algebraic loops are not supported in generated code. Use the 'ashow' command in the Simulink Debugger to see the algebraic loops. If algebraic loops only exist during code generation, please check if configset parameter 'CombineOutputUpdateFcns' is on, set it off might resolve algebraic loops."
Is there a ways to turn off 'CombineOutputUpdateFcns' in Simulink? Trying to do so in the Configuration Parameters is not possible, since this setting is blocked (see figure).
Thank you very much for your help!

回答 (1 件)

stozaki 2022 年 3 月 4 日
see Dependencies section.


Find more on ROS Custom Message Support in Help Center and File Exchange




Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by