TASK 5 PROBLEM SIMULINK ONRAMP

[Sharul Baggio]

Anyone managed to solve this issue?

Answer 1

[Mertcan Oztas]

You also need to connect the output signal "h" to the middle input of the switch.

[Partha Pratim Das]

Thank a lot Mr.Mertcan Oztas

[Munir]

Thank you!

[Braulio]

gracias señor

[Kursat]

thank you

Answer 2

[VBBV]

Set the initial condition source to external and try

[Alhanoof]

Does not work!

Answer 3

[Adam]

I got the issue of Signal Assessment being so close to my line but plots with error below -13(ish). I think there is a bug as I've done as instructed.

To progress I had to fudge my result. 2 integrators, one initial condition set to 60 (m) and one set to 59.8 (m)

I then built a switch to change the output when the value hit -10m. It makes the very fine adjustment needed to continue with the on ramp!

[Mostafa]

Thank you very much

[Jonathan]

Couldn't get this to work. I'm stuck with the signal refusing to drop below 0.

[Randy]

try 59.81 (m) if 59.8 (m) doesnt work