DC motor PI current control block not connecting
1 回表示 (過去 30 日間)
古いコメントを表示
Hi everyone,
I am trying to implement PI current control of a DC motor. I was using the controlled PWM voltage block and H-bridge for the same. I am unable to connect the output of the PI block to the input of the PWM block. I thought it may be because the output of the PI will have units of A and the PWM block was set of voltage. I tried connecting a resistor but again the wire was not connecting them. There is an option for 'unit expression' in the pwm block but I have no clue as to what should be written in there. Could anyone pl explain to me where I am going wrong?
0 件のコメント
回答 (1 件)
Arkadiy Turevskiy
2014 年 10 月 16 日
The output of PI Controller block is the Simulink signal, but the inputs of Controlled PWM Voltage block are Physical Signals- more on the difference here .
You need to convert Simulink signal to Physical Signals to connect two blocks. This example show exactly what you need to do - both in terms of connecting the blocks (look into Feedback Controller subsystem) and in terms of how to tune PID gains.
0 件のコメント
コミュニティ
その他の回答 パワー エレクトロニクス コミュニティ
参考
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!