saving simulation results as .bmp
1 回表示 (過去 30 日間)
古いコメントを表示
I run a simulation from a mfile. there are some scopes in the simulink model and I would like to save these scopes as .bmp. i use saveas(gcf..) command. but at the end it saves another thing.
scopes_currentsDQ
saveas(gcf, ['.\caps\CurrentDQ\', ['CurrentDQ @ Speed=' num2str(SpeedCounter) 'RMS & Torque =' num2str(Torque_Demand) 'Nm'], '.bmp']);
itt does not save the currentsDQ results but a graph of a lookup table which is created before.
0 件のコメント
回答 (1 件)
Titus Edelhofer
2014 年 9 月 12 日
Hi,
if you have only one scope in your model, it's possible by
hFig = findall(0,'tag','SIMULINK_SIMSCOPE_FIGURE')
saveas(hFig, ...)
Note, that findall used this way finds all scopes ...
Titus
2 件のコメント
Image Analyst
2014 年 9 月 12 日
Mehmet's "Answer" moved here:
Hello, I have a lot of scopes. How can I refer a specific scope?
Image Analyst
2014 年 9 月 12 日
Try it and see. In that case hFig is probably a 1-D vector of handles. Refer to the one you want by its index.
参考
製品
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!