MATLAB Answers

Model simulink block connection with different simscape

8 ビュー (過去 30 日間)
Rawaa Almajeez
Rawaa Almajeez 2021 年 8 月 18 日
コメント済み: Rawaa Almajeez 2021 年 8 月 18 日
I am trying to connect a converter model to a grid model. The problem is the grid model was created in old matlab version by using PowerSimSystem. The pictures show how it does not allow me to connect the switch (out side the subsystem) to the current sensor(inside subsystem). Is there any solution for this situation? Any suggestion for another blocks that I could use instead or with my model.
  2 件のコメント
Rawaa Almajeez
Rawaa Almajeez 2021 年 8 月 18 日
Do you mean to replace the switch?Would you please give me more details

サインインしてコメントする。

採用された回答

Joel Van Sickel
Joel Van Sickel 2021 年 8 月 18 日
Hello Rawaa,
you can combine the two technologies as Pemendra says, there are four blocks with names like this "Voltage-Current
Simscape Interface"
However, combining specialized power systems with these blocks will yield a model that is hard to maintain and simulate. It is better to stay in one technology or the other. In this case, just build your new model using specialized power systems components instead of simscape componets. Specialized power systems is included in the Simscape electrical toolbox.
Regards,
Joel
  1 件のコメント
Rawaa Almajeez
Rawaa Almajeez 2021 年 8 月 18 日
Thank you so much. I already tried to use Voltage-Current Simscape interface, but it did not work. The best choice for me right now to build a new model as you advice me.

サインインしてコメントする。

その他の回答 (1 件)

Pemendra Kumar Pardhi
Pemendra Kumar Pardhi 2021 年 8 月 18 日
Dear You can connect single phase voltage source from simelectrical-specialized technology- source. In between port 1 and 2 as shon your figure
  3 件のコメント
Rawaa Almajeez
Rawaa Almajeez 2021 年 8 月 18 日
Thank you so much.

サインインしてコメントする。

コミュニティ

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by