increasing value in stateflow

16 ビュー (過去 30 日間)
Luhur
Luhur 2011 年 7 月 11 日
コメント済み: Antony Smith 2022 年 10 月 12 日
hi all
i want to make condition STATEFLOW, like:
*V=10 X=1 Z=20
if S>=5 && S<=10
then Value V repeatly increase by the value of X until its reach value Z.
so, the value V later could be= 11, 12, 13, 14, 15, 16, 17, 18, 19, 20 then go to next state after reach value Z=20.*
how we did it in stateflow??
thanks

採用された回答

Gerd
Gerd 2011 年 7 月 11 日
Hi Luhur,
assume you have 2 states. One is called increment the other is called nothing. With your S variable checked in a transition you can choose where to go.
Assume S satisfies the criteria and you are right now in state increment. In this state you can write EN:V = V + X; So everytime you enter this state V is incremented by X. From the state increment you can check in a transition if V>=Z and go to the next step.
If you are in state nothing you don't have to do anything just go back and check S again.
Gerd
  4 件のコメント
Luhur
Luhur 2011 年 7 月 12 日
the key is make a function in local stateflow to save data for a while. THANKS GERD!!!
Antony Smith
Antony Smith 2022 年 10 月 12 日
I thought it would be this simple but I am getting a very irritating error:
The data signal was read before being written to.
This error will stop the simulation. State 'variable_1' in Chart 'sens_mtr/Motor Controller/Chart':
signal = signal + 20;
The variable was already given an initial value in a previous block before reacing this block? Any ideas of what causes this?

サインインしてコメントする。

その他の回答 (0 件)

カテゴリ

Help Center および File ExchangeComplex Logic についてさらに検索

製品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by