ADC 1, ADC 2, and ADC 3
Use the three ADC1, ADC2, and ADC3 parameters to configure the ADC for different channels.
DMA transfer complete interrupt is enabled
DMA transfer complete interrupt is enabled by default.
Settings
Default:
off
on
Watchdog interrupt is enabled
Watchdog interrupt is enabled by default
Settings
Default:
off
on
Enable Regular EoCS interrupt
Select Enable regular EoCS interrupt to trigger an ISR from a ADC.
Settings
Default:
off
on
Enable Injected EoCS interrupt
Select Enable injected EoCS interrupt to trigger an ISR from a ADC.
Enable Overrun interrupt
Select Enable Overrun interrupt to trigger an notification when overrun occurs.
Run ADC calibration during model initialization
Select Run ADC calibration during model initialization to perform ADC calibration during model initialization to remove any bias.
This parameter is available only for STM32G4xx and STM32H7xx based boards
Calibration method
Select the ADC Calibration method. You can launch calibration automatically or specify calibration registers manually.
This parameter is available only for STM32G4xx and STM32H7xx based boards
Calibration mode
Select the ADC Calibration mode as Offset
or Offset and linearity
.
This parameter is available only for STM32H7xx based boards
ADC conversion mode
Select the ADC conversion mode for which you want to launch the calibration. ADC conversion can be single ended or differential or both.
This parameter is available only for STM32G4xx and STM32F7xx based boards
Single ended mode offset calibration factor
Specify the ADC single ended offset calibration factor.
This parameter is available only if Calibration mode is set to Specify
calibration register manually
and ADC conversion mode is either
single ended
or both single ended
or
differential
.
This parameter is available only for STM32G4xx and STM32H7xx based boards
Differential ended mode offset calibration factor
Specify the ADC differential ended offset calibration factor.
This parameter is available only for STM32G4xx and STM32H7xx based boards
Linear calibration factor word#
Specify the linear calibration factor word.
This parameter is available only if Calibration method is set to Specify
calibration register manually
and Calibration mode is set to either
Linearity
or both Offset and
Linearity
.
This parameter is available only for STM32H7xx based boards
Refresh
Click Refresh to update configuration parameters according to changes in selected STM32CubeMX project.