GPIO Write

Set logical state of an output pin

• Library:

• NVIDIA Jetson and NVIDIA DRIVE / Basic

• 

Description

Use this block to:

• Create a physical output to a GPIO pin.

• Receive the logical value from other blocks in the model as a stream of boolean values.

• Write the logical value to a GPIO pin at intervals that are determined by Sample time.

Warning

You can damage your target hardware by:

• Shorting a GPIO pin to ground.

• Shorting a GPIO pin with high voltage to another GPIO pin with low voltage.

• Connecting a GPIO pin to a voltage source greater than the maximum voltage.

• Exceeding the maximum current by driving multiple GPIO pins high simultaneously.

Ports

Input

Port_1 — Set the GPIO pin status

scalar

The input port to set the GPIO pin status.

Data Types: single | double | int8 | int16 | int32 | uint8 | uint16 | uint32 | Boolean | fixed point | enumerated | bus

Parameters

Board — Target board name

NVIDIA Jetson TX1 (default) | NVIDIA Jetson TX2 | NVIDIA Jetson Nano | NVIDIA Jetson AGX Xavier | NVIDIA Jetson Xavier NX

Specify the name of the target board. This selection affects the pins available for general purpose input and output.

Programmatic Use

Block Parameter: Board

Type: character vector, string

Values: 'NVIDIA Jetson TX1'|'NVIDIA Jetson TX2'|'NVIDIA Jetson Nano'|'NVIDIA Jetson AGX Xavier'|'NVIDIA Jetson Xavier NX'

Default: 'NVIDIA Jetson TX1'

GPIO number — GPIO pin to write the logical status

0 (default) | scalar

Select a GPIO pin to write the logical status.

To open the pin mapping table, click View pin map. Make sure to assign different pin numbers to the different blocks of your model.

Programmatic Use

Block Parameter: pin

Type: character vector

Values: scalar

Default: '0'

Sample time (seconds) — Time frequency at which block receives data

0.1 (default) | scalar | vector

Specify how often the block should read the port buffer. Enter a value greater than 0 or -1 (for inherited sample time).

When you specify this parameter as-1, Simulink^® determines the best sample time for the block based on the block context within the model.

This value defaults to a sample time of 0.1 seconds. Smaller values require the processor to complete the same number of instructions in less time and this can cause task overruns.

Programmatic Use

Block Parameter: sampletime

Type: character vector

Values: scalar | vector

Default: '0.1'

Version History

Introduced in R2021b