このページの内容は最新ではありません。最新版の英語を参照するには、ここをクリックします。

HTS221 Humidity Sensor

Measure relative humidity and temperature from HTS221 sensor

R2021b 以降

• 

ライブラリ:
Simulink Coder Support Package for STMicroelectronics Nucleo Boards / Sensors

Description

The HTS221 Humidity Sensor block measures relative humidity and ambient temperature using the HTS221 humidity sensor interfaced with the Nucleo/STM32L475-Discovery board. This sensor comprises of a sensing element to measure the relative humidity and temperature.

You can also select an output data rate for the measured values in the block.

端子

Output

Humidity — Relative humidity as measured by HTS221 sensor

scalar

The block outputs the relative humidity in percentage (%).

Dependencies

This output port appears only if you select the Humidity (%) parameter.

データ型: double

Temperature — Temperature measured by HTS221 sensor

scalar

Dependencies

This output port appears only if you select the Temperature (℃) parameter.

データ型: double

Status — Status of pressure and temperature measurements

0 | 1 | -1

Status of pressure and temperature measurements, specified as a 1-by-2 vector. 0 indicates that the data read is new, 1 indicates that the data read is not new, and -1 indicates that the corresponding output is not selected.

Dependencies

This output port appears only if you select the Status parameter.

データ型: int8

Parameters

I2C module — Specify I2C module

2 (既定値) | positive integer

Specify the I2C module on the board. The I2C bus frequency, serial clock (SCL) pin and serial data (SDA) pin are taken according to the corresponding I2C module entry in the configuration parameters.

Humidity (%) — Set output port for reading humidity

on (既定値) | off

Select this parameter to set Humidity as one of the output ports.

Temperature (℃) — Set output port for reading temperature

on (既定値) | off

Select this parameter to set Temperature as one of the output ports.

Status — Set output port for obtaining status

off (既定値) | on

Select this parameter to set Status as one of the output ports.

Output data rate (ODR) — Rate at which humidity and temperature data is sampled

1 Hz (既定値) | 7 Hz | 12.5 Hz

Select the output data rate at which humidity data is sampled.

Sample time — Time interval to read data

-1 (既定値) | positive integer

Specify how often this block reads the data from the HTS221 sensor. When you set this parameter to -1, Simulink determines the best sample time for the block based on the block context within the model.

拡張機能

C/C++ コード生成
Simulink® Coder™ を使用して C および C++ コードを生成します。

バージョン履歴

R2021b で導入