Make the vector [1 2 3 4 5 6 7 8 9 10]
In MATLAB, you create a vector by enclosing the elements in square brackets like so:
x = [1 2 3 4]
Commas are optional, s...
Times 2 - START HERE
Try out this test problem first.
Given the variable x as your input, multiply it by two and put the result in y.
Examples:...
14年弱 前
回答済み connections in pneumatics
Hi Tomas,
Good question. The key to this is that each _node_ needs to have a connection to a volume, not each block. A node...
14年以上 前 | 1
| 採用済み
回答済み Link SimMechanics to Solidwork
With SolidWorks 64-bit and Windows 64-bit, make sure that your MATLAB installation is also 64-bit.
回答済み How Use photodiode model
The port D on the Photodiode is a Physical Signal input port (note the triangle shaped port). This is a unidirectional input wh...
15年弱 前 | 1
回答済み SimMechanics - Joint Actuator/Motion problem
When actuating motion, you should specify position, velocity, _and_ acceleration (not or). When nothing is attached to an input...
15年弱 前 | 0
| 採用済み
回答済み SimMechanics Planar joint trouble shooting
The key thing to observe in that error message is 'mutually dependent definitions'. This can occur when one CS is defined with ...
15年弱 前 | 1
| 採用済み
回答済み How to limit angle for Revolute Block
You are on the right track to a possible solution. Instead of connecting a torque sensor to the joint and feeding back the oppo...