Community Profile

photo

Daniel Stuewe


M4 ENGINEERING, INC.

Last seen: 1日 前 |  2016 年からアクティブ

Followers: 0   Following: 0

連絡

統計

  • First Review
  • Revival Level 1
  • First Answer

バッジを表示

Feeds

表示方法

質問


Simulink tools are not shown at the top of the window
Once in a while (i.e., I can't reliably recreate the problem) when resizing the Simulink window the menus/tools graphics will be...

8ヶ月 前 | 0 件の回答 | 0

0

回答

質問


How to include the effect of lead screw efficiency in a Simscape Multibody lead screw block
I need to include the efficiency of the lead screw (actually a ball screw) in the mechanism I'm simulating. I put together what ...

5年以上 前 | 1 件の回答 | 1

1

回答

質問


Can I put my license on the cloud to run multiple multibody simulations?
I need to run a Monte Carlo analysis of a Simscape Multibody model (on the order of 10,000 samples). Each sample is taking a few...

6年以上 前 | 1 件の回答 | 0

1

回答

質問


How to limit accuracy of simscape multibody output
I have a simulation using Multibody that has a response that is showing far too much precision and I think it is affecting my ru...

7年弱 前 | 1 件の回答 | 0

1

回答

質問


What does this Simulink Modelerror "Compiling the model failed : mech2 InvalidReplacement" mean (and what can I do about it)?
I've been running a Simscape Multibody model for the past several weeks slowly adding functionality. This morning my model ran s...

約7年 前 | 1 件の回答 | 0

1

回答

質問


How can I apply actuation to multiple joints in sequence?
I'm using Simscape Multibody (2nd gen) to model linkage that has two inputs (linkage is made of revolute joints and one elastic ...

7年以上 前 | 1 件の回答 | 0

1

回答

回答済み
How to model backlash in translation ( or slackness) in a revolute joint in simscape second generation?
Rajesh, I've had some luck using a planar joint with hard stops constraining the translational degrees of freedom. I'm modeli...

7年以上 前 | 0

質問


How to integrate simscape driveline clutch with multibody components
I have a component that consists of the lever that can be driven by either a person pushing on the knob on the end or by a DC mo...

8年弱 前 | 1 件の回答 | 0

1

回答

質問


In SimMechanics is it possible to change the Actuation input?
I have a SimMechanics model where one of the inputs is at a Revolute Joint. In some cases I'd like to prescribe the motion at th...

約8年 前 | 1 件の回答 | 0

1

回答