Table - Write results in a new rows
From a measurement, only certain values should be written in a matlab table. These should be written successively in new rows ...

3年以上 前 | 2 件の回答 | 0

### 2

Frequency spectrum - Reading certain y-values
Given is the frequency spectrum of a measurement. The x-axis represents the frequency, the y-axis the amplitude. These are store...

3年以上 前 | 1 件の回答 | 0

### 1

Plot from two curves
Given are two interpolation curves from different measurements with different numbers of measuring points (Example: A=67points, ...

3年以上 前 | 1 件の回答 | 0

### 1

Curve at the peak values
Thanks, with [pkt,lct] = findpeaks(ChannelE,Frequency,'Threshold',0.8); this works quite well. What's the best way to create ...

3年以上 前 | 0

| 採用済み

Curve at the peak values
For the evaluation of measurement results, a curve should be laid through the maximum values (polynomial or spline). Is there a ...

3年以上 前 | 1 件の回答 | 0

### 1

Frequency spectrum - Curve at the maximum values
Hello, How can I generate a curve at the maximum values ​​in Matlab? (See example red curve) Many Thanks!

3年以上 前 | 1 件の回答 | 0

### 1

FFT - Matlab Code not correct
Hello, By means of ultrasonic sensors I made some measurements and would like to evaluate them now via Matlab (data source "d...

4年弱 前 | 1 件の回答 | 0

### 1

FFT - Output maximum values
Hello, Is there an easy way to read the maximum amplitudes with the corresponding frequencies in Matlab after the FFT? Man...

### 0

Matlab FFT - sampling frequency
For the evaluation of ultrasound measurement data the frequency analysis should be carried out by means of Matlab. A sampling f...

### 1

FFT from measured data - Scaling y-axis
Hi all, As a data basis, I have measured data the volts were recorded. Matlab will now be used to perform an FFT. I have th...