How to get the desired frequency in simplified synchronous machine?
4 ビュー (過去 30 日間)
古いコメントを表示
Hello,
when i simulate the model using simplified synchronous machine the output frequency is not proper. The parameters which i am supposed to use to get a frequency of 400Hz is N=6000(the input to the model is 628rad/s), pole pairs=4. when i give this parameter i don't get a freq of 400Hz, why is this? is there any other parameters that i have to change? if so please help me.
8 件のコメント
syed zia
2013 年 5 月 23 日
I also need da same thing ,want to measure the frequency...and its variation after increasing load.........plz help me tnx....
採用された回答
John Doe
2013 年 5 月 6 日
編集済み: John Doe
2013 年 5 月 6 日
The electrical frequency is, as stated in the comments:
f_elec = poles * f_mec / 2
I was wondering what you were doing, because I can't see where you get in trouble. In a synchronous machine, the output frequency is only a function of the number of poles, and the rotor frequency, nothing else.
Since I don't know how you achieved 0.153Hz, I asked to see your model, so that I could try to figure out where your error is.
Thus, the answer to your question: "Is there any other parameters that i have to change?" is No, nothing else must be changed.
Best of luck!
0 件のコメント
その他の回答 (0 件)
参考
カテゴリ
Help Center および File Exchange で Switches and Breakers についてさらに検索
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!