If Action Block that create a stairstep signal in simulink

1 ビュー (過去 30 日間)
Alberto Mora
Alberto Mora 2020 年 6 月 1 日
回答済み: Fangjun Jiang 2020 年 6 月 1 日
Hello,
I have two questions:
  1. I use a If Block to "cut" the signal and not perform some operations (not depicted below). Is it the right approach to use a "If Block" for interupt the signal and don't allow to perform some tasks by the model?
  2. However I notice that after the "If Block" the signal became discrete (see the plot below, where you can see a stairstep plot), even if before the "If Block" the signal was continous (see the plot below, where you can see a continous plot). How to convert again the discrete signal into a continous?

採用された回答

Fangjun Jiang
Fangjun Jiang 2020 年 6 月 1 日
The "sample time" of the Constant block might have been set as "1" second.

その他の回答 (0 件)

製品


リリース

R2019a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by