How to reset diagnostics for particular block?
1 回表示 (過去 30 日間)
古いコメントを表示
Hi, In my simulink simulation I am using a "transport delay" and I think I have disabled some diagnostics regarding this block. But I can not find them. I am trying to find out the buffer size I need to set for one of my simulations but I never get the warning that is mentioned in the help files when the initial buffer size is set to low (even when setting the initial buffer extremely low):
Initial buffer size
Define the initial memory allocation for the number of input points to store
Settings
Default: 1024
- If the number of input points exceeds the initial buffer size, the block allocates additional memory.
- After simulation ends, a message shows the total buffer size needed.
Does anyone know how I can rectify this?
1 件のコメント
Kaustubha Govind
2012 年 11 月 1 日
What is the Maximum Delay setting and what do you provide for the second (transportation delay) input? Perhaps even the extremely low buffer size that you specify is sufficient for your signal if the delay is small enough?
回答 (0 件)
参考
カテゴリ
Help Center および File Exchange で Configure and View Diagnostics についてさらに検索
製品
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!