I am sending and receive data through MCU via SCI communication and set the desired baud rate with connecting the right jumper cables & I am unable to see receive signal ??
古いコメントを表示
Here is the attached model for hosting and testing environment for sending data via external
- I have connected proper jumper wires for Rx and Tx pins on board.
- I have also selected desired baud rate
- I have also selected the corresponding COMx port
- Since, F28027F has SCI A, I've opted SCI A
- The time step is 0.1S and simulation time is inf
- I have also connected hardware via USB cable before turning-on MATLAB Env
Kindly, answer it if there is any steps which I have missed to understand the excerise clearly.

回答 (1 件)
Tridib
2026 年 2 月 20 日
0 投票
It appears that your setup is broadly correct, but a few additional checks can help isolate the issue and ensure SCI communication works reliably. You may try the following:
- Verify that the RX/TX connections are crossed correctly and ensure GND is shared between board and host.
- Confirm that the COM port is not being used by any other application, as this can silently block data reception.
- Check that the selected baud rate on both models (host and target) matches exactly and that no parity/stop‑bit mismatch exists.
- Reduce the baud rate temporarily to check for framing or timing errors.
- Verify that the board is actually running the deployed code.
- Confirm that the SCI‑A GPIO pins are correctly configured for SCI functionality using the appropriate pin multiplexing in your model.
Hope this helps!
カテゴリ
ヘルプ センター および File Exchange で Embedded Coder Supported Hardware についてさらに検索
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!