How to achieve 96 volt from 230v ac voltage ?

1 回表示 (過去 30 日間)
sudarshan Kanse
sudarshan Kanse 2022 年 11 月 30 日
コメント済み: sudarshan Kanse 2022 年 12 月 5 日
I am using 230v AC as my input voltage. A rectifier is used to convert ac to dc, and then a buck converter is employed to step down the voltage. I need 96v But the output voltage of interleaved buck converter is 145v.

採用された回答

Joel Van Sickel
Joel Van Sickel 2022 年 12 月 2 日
All of your controls are open loop. This gives you no ability to change the voltage level. You can either adjust your load resistance to adjust the output voltage (which is likely the wrong way to do this) or adjust your duty cycle down till you have a lower voltage, but in the long run, you need to develop some closed loop controls for this system. Please see the many examples of prebuilt systems to see some closed loop controllers.
Also, you should look at your scope and not the display for this type of system unless you heavily filter your output first. If there is a lot of noise or ripple on your output, the number in the display box is mostly meaningless.
  1 件のコメント
sudarshan Kanse
sudarshan Kanse 2022 年 12 月 5 日
Thank You Joel Van ,Your valuable suggestion has been very helpful to me.

サインインしてコメントする。

その他の回答 (0 件)

カテゴリ

Help Center および File ExchangeElectrical Block Libraries についてさらに検索

製品


リリース

R2022b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by