このページの内容は最新ではありません。最新版の英語を参照するには、ここをクリックします。
設定と構成
Xilinx Zynq プラットフォーム用の組み込みターゲットでは、次のことができます。
Xilinx Zynq プラットフォームに組み込まれている ARM® Cortex®-A プロセッサ上に実行可能ファイルを読み込んで実行する Simulink® モデルをビルドする。
Supported Features for Xilinx Zynq Platformで説明されている機能を使用する。
この組み込みターゲットを取得するには、Install Support for Xilinx Zynq Platformで説明されている手順を実行します。
関数
zynq | Display most recent IP address, user name, and password |
アプリ
ハードウェア ボードでの実行 | 接続されたハードウェア ボード上でのモデルのビルド、展開、および実行 (R2019b 以降) |
モデル設定
トピック
- Supported Features for Xilinx Zynq Platform
List of supported features for Xilinx Zynq Platform.
- Install Support for Xilinx Zynq Platform
Instructions to install support for Xilinx Zynq platform.
- TFTP/WFTPD Configuration Guide
Set up and configure Trivial File Transfer Protocol (TFTP) or Winsock File Transfer Protocol Daemon (WFTPD) to use with your hardware board.
- Hardware Setup Verification
Description of how the Embedded Coder® Support Package for Xilinx Zynq Platform verifies the setup of the Xilinx Zynq hardware board.
トラブルシューティング
Troubleshooting Xilinx Zynq Platform and Development Computer Connection
To check if the Xilinx Zynq platform is properly configured, repeat the steps in TFTP/WFTPD Configuration Guide.
Configure Network Interface Card (NIC) on Development Computer
Configure a Network Interface Card (NIC) on development computer to connect to hardware board.
Get IP Address of Xilinx Zynq Platform
You can get the IP address of the Xilinx Zynq platform from the MATLAB® Command Window or using the Linux® command line.
Command Line Session with Xilinx Zynq Platform
Open a serial command-line session with Xilinx Zynq platform.
Sending PING Request to Xilinx Zynq Platform
Process to PING an Xilinx Zynq platform connected to your development computer.