Before you can start using the Communications Toolbox™ Support Package for USRP® Embedded Series Radio, you must:
Install the support package. See Install Support Package for USRP Embedded Series Radio.
To work with the hardware-software co-design workflow, install additional support packages and third-party tools. See Installation for Hardware-Software Co-Design.
|Create radio object for interfacing with USRP® embedded series radio hardware|
|Download SD card image or bitstream file|
|Get radio hardware information|
|Change IP address, subnet mask, or gateway used by radio hardware|
|Set up MATLAB to work with third-party tools|
|Check connection between host and radio hardware|
|Interface with USRP® E310 or USRP® E312 radio hardware|
Install the support package using the Add-On Explorer.
Follow an automated hardware setup process to establish communication between the host and the radio hardware (Windows only).
Follow a manual hardware setup process to establish communication between the host and the radio hardware.
Set up two radio hardware connected to the same host.
Install and configure additional support packages and third-party tools required by hardware-software co-design workflow.
Uninstall the support package using the Add-On Manager.