Send buffered data to serial port
Simulink Support Package for Arduino® Hardware
Send buffered data to the specified serial port. For more information, see Use Serial Communications with Arduino Hardware.
The Arduino Uno hardware
has one serial port device, serial port 0, connected to the digital
TX 1 and
RX 0. If
you set the Port number parameter to
this block transmits over the digital pin marked
The block input accepts vector or scalar uint8 data. To convert a data source to uint8, use a Data Type Conversion block.
During simulations without the hardware, this block does nothing.
If you use this block in models with the Standard Servo Read, Standard Servo Write, and Continuous Servo Write blocks, use longer sample times to avoid overruns.
Warning Do not connect the serial port pins to an RS-232 serial interface, such as the DE-9M connector on a computer, without limiting the voltage. The RS-232 standard allows higher voltages that can damage your hardware. For details, read the documentation for your Arduino hardware.
Enter the number of the serial port.
Click View pin map to open the Arduino Pin Mapping table.
To know about the fixed ports and the allocated pins for the block, see Pin Mapping on Arduino Blocks.
Note: To change the Target hardware parameter, select Tools > Run on Target Hardware > Options.
You can assign a Serial Transmit block and a Serial Receive block to the same serial port.
Do not assign multiple Serial Transmit blocks to the same serial port.
Do not assign the pin numbers used by the serial port to other blocks within the model.
Serial port 0 is connected to the USB port through a converter. Do not use both serial port 0 and the USB port at the same time. For example, do not use serial port 0 if you intend to use External mode, because External mode requires the USB port.